I am trying to install my tial waste gate. I'm pretty sure it is a 38mm. I had an eBay waste gate before and the valve seatbdid not fit. So I bought a tial 38mm valve seat and it still doesn't sit flush with the waste gate, or is it suppose to stick out. If so does the fatter end of it go in the waste gate or the little lipped part... Neither end fits into my manifolds hole... Could it be a 35mm hole?

That's normal, keep tightening it. The spring will compress a bit, allowing the valve to be pushed upward to make room for the seat. When the gate is installed tightly against the flange, it creates a constant pressure between the gatevalve seat and the valve.

MORE NEWS

2011-02-23

Back