You are here:
News
News
O-type pneumatic ball valve 2011-06-01
O-intensive small air valve is made by the introduction of Japanese technology coupled with 63000RA 301K O-type ball valve series of fine small rotary actuator components. It is powered by compressed air, driven ball club can turn 90 degrees to achieve full
ball valve and gate valve 2011-05-31
With this, compared to a gate valve opening and closing time is short, the operating torque, installation space is small and light weight characteristics, some division of labor instead of using butterfly valves. But all along, butterfly valve sealing performance did not fully meet the market requir
water control valve 2011-05-30
water control valve are drip irrigation valves that turn on and off water to the drip tubes (or hoses). Often these valves are automatically turned on and off by an irrigation controller/timer.
For a small drip irrigation system you may need only one zone control valve. While for bigger drip irrigat
Plastic Products 2011-05-27
Household items: Most of the plastic products include various
types of household products such as buckets, brooms, mugs, bristles and
brushes. Polypropylene is a form of plastic that is used to manufacture
different items such as food containers, pressure pipes, bottles,car hinges and gate valves
how does the check valve work 2011-05-26
Check Valves allow medium to flow in one direction only, stop medium which flow in opposite direction .usually
these valve work automatically. Under the action of pressure of fluid which flow in one direction, the disc open. When fluid flow in
opposite direction .the fluid is cut down by the pre
Evaporative Emission Canister Purge Solenoid Valve 2011-05-25
After much listening to any odd under hood noises, I noticed the EVAP
canister purge solenoid was making alot of noise. It sounds like a
"clicking" or "knocking" so I ordered a new one to see if that would
help a little with the noise. It did not.
The new one is just as noisy as the old one. Aft
The secret behind the nylon ball valve 2011-05-24
A few days ago I read "Today Yuhuan", see the October 8, 2007 line reads: "In 1982, with Sand Casting Process-based enterprises run by the village clerk hose, from the introduction of a foreign trade company in Qingdao ball processing of samples and a single small business
Wiring water Level Switch to Solenoid Valve 2011-05-23
I have a solenoid valve just like this and its rated 120 VAC/26VA (3 prongs, one for ground) . I also have a
horizontal level switch for liquid like this
http://germes-online.com/direct/dbimage/50279527/Level_Switch.jpg with
rating 120 VAC/0.28 A (the switch will connect when the water level
rea