Control Valve Series

Product drawing»

Structural drawing»

You are here: News

News

The flapper valves 2011-09-02
For less noise or better removal of lubricating oil mist, use a more restrictive muffler (smaller micron pore size), which slightly decreases flow. Also, the small, sintered bronze ones don't get broken off like the larger plastic ones. --- AOD pump body construction. For emptying 55-gallon drums
Balance each loop with gate valves 2011-09-01
I will balance each loop with gate valves (or any ideas?) on the return manifolds, using temporary temperature gauges clamped onto each return pipe to get even return temps. I will put stopcocks on the input valves = for isolation purposes.I intend to only use the in-built boiler pump to circulate
Outdoor Fireplace Grill and Fireplace Designs 2011-08-30
Outdoor Fireplace Grill and Fireplace Designs An important merchandise for social gathering gatherings and romantic evenings, an out of doors fireplace grill adds a classic touch and charm to the garden, patio, pool region or the yard. Fireplace grills in distinctive models and finishes are on h
Leaky safety valve and/or sight glass 2011-08-29
If its just the 0 -> 10 V into a 0 ->1.4A, then build a precision rectifier as per inventor(y)'s suggestion, then use an op-amp with a power transistor using the solenoid as its collector load, and a low value resistor (1 ohm) in the emitter circuit. So now you have a monitoring point for the so
The light spring returns the piston 2011-08-26
About 3-way Solenoid Valve Operation I took the brewhead 3-way solenoid valve off, and surprisingly I found the spring around that solenoid nucleus is a lot softer than I would expect. I know the pressure from brewing boiler could get about 12 bars when water expands, so how could this spring h
Oil tanks and gas lines 2011-08-25
Electrical
The pipe should go across and down 2011-08-24
there should be a drian off valve at the bottom somewhere, connect a hose to that (with the other end outside or in a toilet), Switch water off, either by the tank or to the whole house, Switch boiler off and open drain off valve. If no drain off valve, then you can turn boiler off, turn wate
Determine the size of the valve 2011-08-23
needed based on the system demands. The term fall-off refers to the difference between the pressures on the valve outlet and the inlet pressure. If the demand is more, there will be a greater fall-off. Study the performance curve provided by the valve manufacturer. These charts, also known as valv
Shanghai MeiYan Yi Pump & Valve Co., Ltd.
MeiYan Yi control valve Contact MeiYan Yi
Shanghai Enine Pump & Valve Co., Ltd.
Enine control valve Contact Enine
Shanghai Saitai Pump & Valve CO., Lid.
Saitai control valve Contact Saitai
Shanghai Fengqi Industrial Development Co., Ltd.
FengQi control valve Contact FengQi